2009 RX 350, 前刹车内侧与外侧磨损严重不一致,请教专家是什么原因?看图

X
X5_XDM
楼主 (文学峸)

内侧刹车盘和刹车片都磨损出沟痕。外侧却很平整。 什么原因?
难道是因为内侧更靠近caliper?

第一张是外侧,第二张是内侧的

M
MoonRiverMe
Check rotor interior surface for uneven wear
O
Oneshotkill
锈的一塌糊度的图片不已经说明了一切?其实只要刹车无异常,无噪音,力度无衰退,用到皮薄也没问题。
O
Oneshotkill
不过有钱可以任性,碟皮都换固然最好,只要刹车正常【碟太薄除外】,反正换我是不会换滴。
h
hellotom
检查caliper sliding pins, clean and add caliper grease. 确认滑动正常

不然换了新的刹车皮,还会发生同样的问题。

老金工
09年以来还是原装rotor?可能要换了,4 ur safety reasons

"Disc brake rotors usually last so long that many people treat them as 'fit and forget' components. However, manufacturers provide minimum thicknesses for their rotors. Shimano recommends that its rotors, which start out 1.8mm thick, should be replaced when the braking surface has been reduced to 1.5mm." ...... "Brake rotor thickness is a crucial measurement for your vehicle's safety. It is important to know your vehicle's minimum brake rotor thickness because if the rotor is thinner than the minimum thickness, it can be dangerous to operate. Thinner rotors are lighter in weight and less able to absorb and dissipate heat." Brake rotor thickness is a crucial measurement for your vehicle's safety. It is important to know your vehicle's minimum brake rotor thickness because if the rotor is thinner than the minimum thickness, it can be dangerous to operate. Thinner rotors are lighter in weight and less able to absorb and dissipate heat.
s
soccer88
同意,刹车盘和刹车皮都该换了,怀疑用了便宜刹车皮,有朋友的RAV4一样现象
c
chinomango
蝶皮还有很多。边缘似乎擦到什么东西上了
M
MoonRiverMe
再细看了下图才看到rotor都烂成这样了

Rotor得换,caliper guiding pin or cylinder 都可能绣死了不能回位。

坚茂
卡钳的滑动杆缺乏润滑,导致刹车片无法或者延迟松开而增加模式,09年到现在才换,一般是滑动杆的润滑问题
坚茂
这么久才换,说明开车非常柔和,这种驾驶模式,其实只要换刹车片就可以,润滑滑动杆即可,经济实惠为主
老金工
内侧rotor磨出二个台阶,下一步说不定会磨出“涡轮“状:

X
X5_XDM
真诚感谢诸位大拿们的建议和回复。rotor还是原装的,烂的不行了。slide pin也粘住了。今天花了一下午统统换掉。

刚刚换了新的rotor 和 pad。同时发现一个caliper上piston 的橡胶密封圈烂了。又换了个caliper。 

目前感觉良好。

M
MoonRiverMe
锈成这样决非是一日之寒所能,从来就没换过刹车皮?
X
X5_XDM
车开了这些年好像只换过1-2次刹车片。有一次还是dealer告说我说一侧的已经磨没了。这辆是老婆的车,每天就是

上下班加买菜。

i
iGarage
哎,自己开叉5,LD车子不关心
M
MoonRiverMe
老婆的车我隔三差五的就得开开看看有哪儿不妥

她嘛,轱辘飞掉也许都不会知道。

X
X5_XDM
向两位大拿们学习,虚心接受批评。这辆车还是09年经济危机时捡了个便宜,fully loaded 出门价$368000

LD 开着顺手一直不肯换。好在没什么毛病,也没有太多复杂的电子控制。常规维护我都可以自己做了。

本想该换一辆,结果现在买车利息如此之高,于是下决心耐心等待下一次经济危机到来再换车。

估计明年上半年也许就有机会看见车商大甩卖了。