Q. Why does my bottle leak? A. The patented vent provides an air passage way that allows air to enter the bottle which allows the baby to nurse without fighting the negative affects of the vacuum found in other baby bottles. Under certain conditions the milk or formula can exit through the vent. For example if the liquid is overheated the expanding air inside the bottle pushes the liquid through the vent causing leakage. Or if the bottle is shaken to mix formula the liquid may enter the vent and leak. Also if the bottle isn't held properly and the end of the reservoir tube is submerged in the fluid leakage may occur.
Q. What to do in the unlikely case of bottle leakage. A. When liquid gets into the venting system, it can sometimes leak out around the teat collar. This can happen three ways: If you heat your bottle with the teat collar securely in place, the liquid will be forced up into the vent as it expands. To avoid this, either heat the bottle without the teat collar or loosen the teat collar one-half turn after heating to allow the pressure to equalise. Then, re-tighten it before feeding. If you use powdered formula and mix it by shaking the bottle, liquid can get into the vent. The solution for this is to mix the formula by stirring it with a spoon rather than by shaking. If you overheat the liquid in the bottle, the vapour will rise and condense in the vent. To prevent this, avoid warming the liquid beyond body temperature.
☆ 发自 iPhone 华人一网 1.14.01
☆ 发自 iPhone 华人一网 1.14.01
Q. Why does my bottle leak?
A. The patented vent provides an air passage way that allows air to enter the bottle which allows the baby to nurse without fighting the negative affects of the vacuum found in other baby bottles. Under certain conditions the milk or formula can exit through the vent. For example if the liquid is overheated the expanding air inside the bottle pushes the liquid through the vent causing leakage. Or if the bottle is shaken to mix formula the liquid may enter the vent and leak. Also if the bottle isn't held properly and the end of the reservoir tube is submerged in the fluid leakage may occur.
Q. What to do in the unlikely case of bottle leakage.
A. When liquid gets into the venting system, it can sometimes leak out around the teat collar. This can happen three ways:
If you heat your bottle with the teat collar securely in place, the liquid will be forced up into the vent as it expands. To avoid this, either heat the bottle without the teat collar or loosen the teat collar one-half turn after heating to allow the pressure to equalise. Then, re-tighten it before feeding.
If you use powdered formula and mix it by shaking the bottle, liquid can get into the vent. The solution for this is to mix the formula by stirring it with a spoon rather than by shaking.
If you overheat the liquid in the bottle, the vapour will rise and condense in the vent. To prevent this, avoid warming the liquid beyond body temperature.
我还试过直接倒一杯Tap water,装好了然后吸奶嘴,吸着吸着奶就从瓶口那个拧紧的地方漏出来。
这个漏不是一开始就漏,而是吃奶过程中你会看见有奶渐渐渗入了那个瓶口的拧盖处,然后娃再吃几口,奶就一滴一滴出来了
☆ 发自 iPhone 华人一网 1.14.01
你加里面那个吸管了吗?那个必须加,虽然说新版可以不加但是其实不行 ---发自Huaren 官方 iOS APP
vent和瓶子要按紧,那个有时候不好按紧,我用的就是宽口的
加了里面的管子啊!而且奶不用热啊,新鲜泵的,但是就是漏
☆ 发自 iPhone 华人一网 1.14.01
我家的窄口也漏!我买了9个,最后全扔了,换momma和贝亲。